Pauline O.
Trustpilot27 May 2025
I was very pleased with the service
I was very pleased with the service. Next day appointment, reasonable price, great communication and a thorough and tidy job done by a very personable employee. Cannot fault it.
Audi A3 rear window replacement — instant quote across 14 active variants, fitted by approved fitters near you, booked in under two minutes.
Make
Audi
Model
A3
No card required · Free to quote
Replacement cost varies with generation and equipment — earlier A3s without antenna integration are typically the most affordable, while later models carrying integrated radio antennas, GPS receivers, or alarm-circuit wiring add complexity to sourcing and fitting. Green-tinted variants and encapsulated trim (where a rubber gasket is factory-bonded to the glass edges) also influence pricing.
| Year | Price range | Variants | Quote |
|---|---|---|---|
| 2026 | £493 — £502 | 2 variants | Price my 2026 |
| 2025 | £493 — £502 | 2 variants | Price my 2025 |
| 2024 | £493 — £502 | 2 variants | Price my 2024 |
| 2023 | £493 — £502 | 2 variants | Price my 2023 |
| 2022 | £493 — £502 | 2 variants | Price my 2022 |
| 2021 | £493 — £502 | 2 variants | Price my 2021 |
| 2020 | £373 — £582 | 4 variants | Price my 2020 |
| 2019 | £373 — £582 | 2 variants | Price my 2019 |
| 2018 | £373 — £582 | 3 variants | Price my 2018 |
| 2017 | £373 — £582 | 3 variants | Price my 2017 |
| 2016 | £373 — £582 | 3 variants | Price my 2016 |
| 2015 | £373 — £582 | 3 variants | Price my 2015 |
| 2014 | £373 — £582 | 3 variants | Price my 2014 |
| 2013 | £357 — £628 | 5 variants | Price my 2013 |
| 2012 | £357 — £628 | 8 variants | Price my 2012 |
| 2011 | £357 — £628 | 5 variants | Price my 2011 |
| 2010 | £357 — £628 | 5 variants | Price my 2010 |
| 2009 | £357 — £628 | 5 variants | Price my 2009 |
| 2008 | £357 — £628 | 5 variants | Price my 2008 |
| 2007 | £357 — £628 | 5 variants | Price my 2007 |
| 2006 | £357 — £628 | 5 variants | Price my 2006 |
| 2005 | £357 — £628 | 5 variants | Price my 2005 |
| 2004 | £357 — £628 | 6 variants | Price my 2004 |
| 2003 | £338 — £627 | 4 variants | Price my 2003 |
| 2002 | £338 — £383 | 2 variants | Price my 2002 |
| 2001 | £338 — £383 | 2 variants | Price my 2001 |
| 2000 | £338 — £383 | 2 variants | Price my 2000 |
| 1999 | £338 — £383 | 2 variants | Price my 1999 |
| 1998 | £338 — £383 | 2 variants | Price my 1998 |
| 1997 | £338 — £383 | 2 variants | Price my 1997 |
| 1996 | £383 — £383 | 1 variant | Price my 1996 |
The displayed range is an indicator — the final price is produced by the quote form after you confirm your variant. Older A3s can still be booked.
Showing 14 reviews from verified Audi A3 owners. Across the whole of UK Car Glass, 4.82/5 from 1,456 Trustpilot reviews.
Booking a rear-window replacement with UKCG follows a simple journey from quote to fit.
Answer a short online quiz about your A3 (year, trim, features) to get an instant quote.
Review the quote and book your preferred date — mobile fitting at your address or a local workshop, your choice.
UKCG's parts team confirms your exact glass variant and sends a summary before the fitting day.
A specialist fitter arrives with your replacement glass; fitting typically takes 30–60 minutes depending on your car.
Your fitter will remove as much broken glass as they can reach during the job, but small shards can lodge in places like under seats or seatbelt mechanisms — we recommend a professional valet afterwards for thorough interior detailing.
You're covered by a two-year warranty on workmanship and glass quality.
Your replacement rear window is matched to factory spec and UK-legal from the moment it's fitted.
Most A3 rear-window replacements can be done mobile at your address — a specialist fitter will come to you with the glass and complete the job there. However, if your A3 is fitted with certain integrated systems or if weather conditions make a mobile visit impractical, a workshop slot may be more suitable.
Your choice at booking — select mobile or workshop based on what works best for you. The fitting time and warranty remain the same either way.
We confirm the specific answer for your vehicle when you book.
Tap a feature to see what it is, how to spot it on your car, and how it affects glass replacement. We confirm the exact match for your vehicle when you book.
Heated rear windscreen with integrated wires clears mist and ice when you switch on the demister.
A heated rear windscreen contains fine heating wires embedded within the glass. When you activate the rear demister, an electrical current passes through these wires, warming the glass and melting ice or condensation. This feature is particularly useful in cold or damp weather, improving rear visibility quickly. The heating grid is integral to the glass and connected to your vehicle's electrical circuit via connectors at the base of the windscreen.
Look at the rear windscreen from inside the vehicle — you will see a fine grid of horizontal lines across the glass, typically bronze or copper in colour. On the dashboard or steering wheel stalk, there will be a dedicated rear-demist button, usually marked with a windscreen symbol and heating lines. If in doubt, ask your vehicle's service centre or consult your handbook.
Replacement rear windscreens with heated grids are widely available as original-equipment aftermarket or dealership parts. The new glass must include the factory heating grid and electrical connectors intact. The technician will reconnect the heating circuit to your vehicle's rear-demist switch. Heated rear windscreens are bonded glass, so adhesive cure time applies; drive-away time will be confirmed by the fitter on the day.
An aerial laminated into the windscreen or rear window restores radio, DAB or TV reception without a roof-mounted mast.
An antenna is a conductive print laminated into the glass during manufacture, typically used for radio, DAB (digital audio broadcasting) or television reception. It replaces the traditional roof-mounted aerial mast found on older vehicles. The antenna is integrated into the glass interlayer and connected to the vehicle's receiver unit via a connector embedded in the glass edge. This design offers a cleaner aesthetic, reduces wind noise, and eliminates the vulnerability of a protruding mast to damage or theft.
Check your vehicle's roof — if there is no visible aerial mast, your car likely has a laminated antenna. You can also ask your dealer or service centre whether your windscreen or rear window carries an antenna print. The connector may be visible on the glass edge or inside the door frame trim.
When replacing glass with a laminated antenna, the replacement must carry the matching antenna print and connector to restore reception immediately on fitting. Aftermarket or original-equipment glass with the correct antenna specification is essential; a plain replacement will leave you without radio or DAB signal. Our fitters verify the antenna specification during booking and source the correct variant before the appointment.
Green tint reduces glare and improves visual comfort by filtering certain light wavelengths.
Green tint is a light-filtering coating applied to the glass during manufacture. It absorbs and reduces transmission of certain wavelengths of light, primarily to cut glare from sunlight and reflections. The tint is subtle — often barely visible to the naked eye — but measurably improves visual comfort during prolonged driving, particularly in bright conditions. It's a factory specification chosen by the vehicle manufacturer to balance daylight comfort with interior visibility and aesthetic consistency across all glass in the vehicle.
The easiest way to check is to roll your side window halfway down and hold a piece of white paper behind it. Look carefully for a tint cast — green tint will appear as a subtle green hue compared to clear glass. Your windscreen will have the same tint as your side windows. You can also ask your vehicle's dealership or service centre — they'll have the original specification on file.
Green-tinted replacement glass must match the original tint specification to maintain visual consistency across all windows and preserve the vehicle's interior aesthetics. Aftermarket OE-equivalent (OEE) green-tinted glass is widely available, though some vehicles may require original equipment (OEM) dealership glass if the tint specification is proprietary. Tint does not affect calibration, cure time, or installation procedure — it's a cosmetic and functional specification only.
Solar control glass absorbs infrared rays to reduce heat and improve cabin comfort.
Solar control is a coating applied to the windscreen that absorbs the sun's infrared radiation rather than allowing it to pass through into the cabin. This reduces solar heat gain, helping to keep the interior cooler and more comfortable, particularly in warm weather or direct sunlight. The coating is transparent to visible light, so it doesn't darken the windscreen or affect visibility. It's a passive thermal management feature that works continuously whenever the sun is shining on the glass.
Check your vehicle's specification sheet or contact your dealership service centre to confirm whether solar control glass is fitted. Some manufacturers list it as 'solar control windscreen', 'heat-reflective glass', or 'thermal management glass'. It's a factory-fitted feature and won't be visibly obvious from outside the car — the coating is integral to the glass itself.
Solar control glass is a factory-fitted specification. When replacing the windscreen, a solar control variant must be sourced to match the original. This is a standard glass type with no special fitting implications or calibration requirements. Cure and drive-away times follow normal windscreen bonding procedures. Confirm with your fitter that the replacement glass includes solar control to maintain the original thermal performance.
GPS antenna built into the windscreen connects your sat-nav to satellite signals for reliable navigation.
A GPS antenna is laminated into the windscreen glass during manufacture, providing a direct aerial connection for your vehicle's satellite-navigation system. This integrated design offers better signal reception than external antennas and a cleaner aesthetic. The antenna print and electrical connector are engineered into the glass itself, allowing the navigation receiver to lock onto GPS satellites without interference from the vehicle's metal body or other components.
Check your vehicle's handbook or ask your dealership service centre whether your windscreen carries an integrated GPS antenna. You won't see obvious external aerials or connectors on the glass itself — the antenna is laminated internally. If your sat-nav works reliably without a visible roof-mounted antenna, it's likely GPS-equipped.
Replacement windscreens with GPS antennas must be sourced as OEM (original-equipment) glass to preserve navigation functionality. The antenna print pattern and electrical connector are specific to your vehicle's sat-nav system. Aftermarket glass without the antenna print will not support GPS reception. We confirm OEM availability when you book; lead times may be slightly longer than standard glass.
Dark grey tint on rear windows provides privacy and reduces interior heat and glare.
Dark grey tint, formally known as privacy glass, is a factory-applied tint created through a deep-dipping process during glass manufacture. The pigment is infused into the inner surface of the glass, darkening the rear windows (and sometimes rear doors) significantly more than the front. This reduces heat transmission, minimises glare, and obscures the interior from outside view. It's standard on the rear half of many modern vehicles.
Compare the rear side windows and rear window (backlight) to the front side windows — the rear glass will be noticeably darker. Check your vehicle documents or ask your dealership service centre if you're unsure whether your car left the factory with privacy glass.
Dark grey tinted glass must be sourced from the Original Equipment Equivalent (OEE) or dealership to ensure colour and transmission match your vehicle's existing rear glass. The tint is integral to the glass itself, not a surface coating, so aftermarket non-tinted glass will look visibly mismatched. Replacement does not require any calibration and follows standard bonded-glass cure times for rear windows.
A TV-reception aerial printed into the rear window, typically for in-car entertainment systems.
A TV antenna is an aerial pattern laminated into the rear windscreen or rear side window to receive broadcast television signals. It's a separate system from the vehicle's radio or mobile antenna and is typically found in vehicles equipped with rear-seat entertainment systems. The antenna is printed directly onto or into the glass during manufacture, so when the glass is replaced, the antenna pattern must be reproduced on the replacement to maintain reception quality.
Check your vehicle's specification sheet or handbook for rear-seat entertainment or TV tuner capability. If your car has a rear-seat entertainment system with a TV tuner, the rear window will have a TV antenna. You can also ask your dealer or service centre to confirm whether your vehicle has this feature.
When the rear window is replaced, the replacement glass must include the matching TV antenna print to preserve reception. OEM (original equipment manufacturer) glass is typically required to ensure the antenna pattern is identical. The antenna is passive and requires no calibration or specialist procedures after fitting. Cure time for bonded rear glass is required; the fitter will confirm the drive-away time on the day.
A brake light integrated into the rear window glass itself, requiring a matching replacement to reconnect the original lighting circuit.
A brake light integrated into the rear window glass is a lighting element built directly into the glass panel during manufacturing. Rather than using a separate lamp cluster mounted to the vehicle body, the light circuit is routed through conductive elements — typically a silkscreen pattern, wire network, or bracket assembly — embedded in or bonded to the glass itself. When you brake, this integrated light illuminates to warn following traffic. It combines functionality with design integration, reducing the number of separate components on the rear of the vehicle.
Check your vehicle's rear window for a visible pattern of fine lines or wires running across the glass, usually near the top edge or spanning the upper portion. Look at your vehicle's manual or contact your dealer's service centre — they can confirm whether your rear window carries an integrated brake light. If you see a separate brake-light cluster mounted to the bodywork instead, your vehicle does not have this feature.
The replacement rear window must carry the identical integrated brake-light pattern so the original lighting circuit reconnects without modification. The conductive elements — whether silkscreen, wiring, or bracket fittings — must align precisely with the vehicle's electrical connections. Using a standard rear window without this pattern would disable the brake light. We source the correct OE-specification glass to ensure a seamless fit and restore full functionality.
The Audi A3 has been in continuous production since 1996, evolving through five generations. Early models carried straightforward toughened rear glass, while later generations introduced antenna integration for radio and sat-nav reception, along with optional green-tinted variants on certain trims.
From the mid-2010s onwards, many A3 variants gained additional smart glass features — antenna systems became standard on higher specs, and some models incorporated GPS or alarm-circuit integration. Current-generation A3s (2020 onwards) across the range carry these integrated antennas as part of their infotainment wiring architecture.
Rear-window replacement accounts for these features; the glass you receive matches your car's original specification, including any antenna, tinting, or trim encapsulation.
Own a different Audi? We've got you — every variant, every year.
The questions customers ask us most often.