Alfa Romeo Brera rear window replacement — booked online.

What to expect during your Alfa Romeo Brera rear window replacement

Booking a rear window replacement through UK Car Glass is straightforward — from quote to fitting in a few simple steps.

1. 1

   Complete our quick online quote via the guided quiz (takes about a minute) to identify your exact variant and confirm your rear window specification.

2. 2

   Our parts check team verifies the correct glass type and any features like antenna or solar control before your booking is confirmed.

3. 3

   You're matched with an approved fitter near you; they'll arrange a time that suits your schedule — most jobs are fitted mobile at your address.

4. 4

   On fitting day, your fitter removes the shattered glass and clears accessible shards, then bonds and seals the new rear window in place. Typical fitting takes 30–60 minutes of the fitter's time.

5. 5

   Your fitter confirms the minimum drive-away time before leaving — this depends on the adhesive used and ambient conditions. We recommend a professional valet afterwards to remove any glass particles that may have lodged in the interior.

6. 6

   You're covered by a two-year warranty on workmanship and glass quality, and our team is on hand if any questions arise.

The entire process — from booking to fitting — is designed to be straightforward, transparent, and backed by our two-year warranty.

What features does your Brera have?

Tap a feature to see what it is, how to spot it on your car, and how it affects glass replacement. We confirm the exact match for your vehicle when you book.

• Green2

  2006–2010

  Green tint reduces glare and improves visual comfort by filtering certain light wavelengths.

  What it means

  Green tint is a light-filtering coating applied to the glass during manufacture. It absorbs and reduces transmission of certain wavelengths of light, primarily to cut glare from sunlight and reflections. The tint is subtle — often barely visible to the naked eye — but measurably improves visual comfort during prolonged driving, particularly in bright conditions. It's a factory specification chosen by the vehicle manufacturer to balance daylight comfort with interior visibility and aesthetic consistency across all glass in the vehicle.

  How to tell

  The easiest way to check is to roll your side window halfway down and hold a piece of white paper behind it. Look carefully for a tint cast — green tint will appear as a subtle green hue compared to clear glass. Your windscreen will have the same tint as your side windows. You can also ask your vehicle's dealership or service centre — they'll have the original specification on file.

  Replacement impact

  Green-tinted replacement glass must match the original tint specification to maintain visual consistency across all windows and preserve the vehicle's interior aesthetics. Aftermarket OE-equivalent (OEE) green-tinted glass is widely available, though some vehicles may require original equipment (OEM) dealership glass if the tint specification is proprietary. Tint does not affect calibration, cure time, or installation procedure — it's a cosmetic and functional specification only.

• Heated Rear Windscreen2

  2006–2010

  Heated rear windscreen with integrated wires clears mist and ice when you switch on the demister.

  What it means

  A heated rear windscreen contains fine heating wires embedded within the glass. When you activate the rear demister, an electrical current passes through these wires, warming the glass and melting ice or condensation. This feature is particularly useful in cold or damp weather, improving rear visibility quickly. The heating grid is integral to the glass and connected to your vehicle's electrical circuit via connectors at the base of the windscreen.

  How to tell

  Look at the rear windscreen from inside the vehicle — you will see a fine grid of horizontal lines across the glass, typically bronze or copper in colour. On the dashboard or steering wheel stalk, there will be a dedicated rear-demist button, usually marked with a windscreen symbol and heating lines. If in doubt, ask your vehicle's service centre or consult your handbook.

  Replacement impact

  Replacement rear windscreens with heated grids are widely available as original-equipment aftermarket or dealership parts. The new glass must include the factory heating grid and electrical connectors intact. The technician will reconnect the heating circuit to your vehicle's rear-demist switch. Heated rear windscreens are bonded glass, so adhesive cure time applies; drive-away time will be confirmed by the fitter on the day.

• Solar Control2

  2006–2010

  Solar control glass absorbs infrared rays to reduce heat and improve cabin comfort.

  What it means

  Solar control is a coating applied to the windscreen that absorbs the sun's infrared radiation rather than allowing it to pass through into the cabin. This reduces solar heat gain, helping to keep the interior cooler and more comfortable, particularly in warm weather or direct sunlight. The coating is transparent to visible light, so it doesn't darken the windscreen or affect visibility. It's a passive thermal management feature that works continuously whenever the sun is shining on the glass.

  How to tell

  Check your vehicle's specification sheet or contact your dealership service centre to confirm whether solar control glass is fitted. Some manufacturers list it as 'solar control windscreen', 'heat-reflective glass', or 'thermal management glass'. It's a factory-fitted feature and won't be visibly obvious from outside the car — the coating is integral to the glass itself.

  Replacement impact

  Solar control glass is a factory-fitted specification. When replacing the windscreen, a solar control variant must be sourced to match the original. This is a standard glass type with no special fitting implications or calibration requirements. Cure and drive-away times follow normal windscreen bonding procedures. Confirm with your fitter that the replacement glass includes solar control to maintain the original thermal performance.

• Antenna1

  2006–2010

  An aerial laminated into the windscreen or rear window restores radio, DAB or TV reception without a roof-mounted mast.

  What it means

  An antenna is a conductive print laminated into the glass during manufacture, typically used for radio, DAB (digital audio broadcasting) or television reception. It replaces the traditional roof-mounted aerial mast found on older vehicles. The antenna is integrated into the glass interlayer and connected to the vehicle's receiver unit via a connector embedded in the glass edge. This design offers a cleaner aesthetic, reduces wind noise, and eliminates the vulnerability of a protruding mast to damage or theft.

  How to tell

  Check your vehicle's roof — if there is no visible aerial mast, your car likely has a laminated antenna. You can also ask your dealer or service centre whether your windscreen or rear window carries an antenna print. The connector may be visible on the glass edge or inside the door frame trim.

  Replacement impact

  When replacing glass with a laminated antenna, the replacement must carry the matching antenna print and connector to restore reception immediately on fitting. Aftermarket or original-equipment glass with the correct antenna specification is essential; a plain replacement will leave you without radio or DAB signal. Our fitters verify the antenna specification during booking and source the correct variant before the appointment.

• Alfa Romeo 156 From £301
• Alfa Romeo Mito From £349
• Alfa Romeo Giulietta From £352
• Alfa Romeo 146 From £376
• Alfa Romeo 159 From £383
• Alfa Romeo GT From £428
• Alfa Romeo 147 From £485
• Alfa Romeo 166 From £494
• Alfa Romeo GTV From £708